TVHEADEND / TBS 6205 kuvan pikselöitymiseen / korruptoitumiseen

-
I got this response from TBS support to try a different driver set... 

sudo rm -rf /lib/modules/`uname -r`/kernel/drivers/media/
wget http://www.tbsiptv.com/download/common/tbs-linux-drivers_v170330.zip
unzip tbs-linux-drivers_v170330.zip
tar jxvf linux-tbs-drivers.tar.bz2
cd linux-tbs-drivers
 ./v4l/tbs-x86_64.sh
 make -j4
 make install

 reboot and they also said and set your system like this :

create text file "/etc/modprobe.d/tbs.conf" with line:
options tbs_pcie-dvb tbs_int_type=1
options saa716x_tbs-dvb int_type=1

after reboot, check with "cat /proc/interrupts" that it reports MSI for TBS PCIE.

Popular posts from this blog

Tasmota calibration and setup

-
Image
Tasmota default IP: 192.168.0.4 Connect to WLAN Install OTA updates (Firmware Updates from front page) Calibrate Tasmota PowerSet 60.0 (if load is ie. 60w lamp) VoltageSet 231.1 (measured voltage) CurrentSet 259.740 (calculated value) https://tasmota.github.io/docs/Power-Monitoring-Calibration/ Set correct timezone from console (ie. Finland): Backlog0 Timezone 99; TimeStd 0,0,10,1,4,120; TimeDst 0,0,3,1,3,180 Set password and MQTT settings as needed
Read more

/etc/rc.local hdparm disk spindown asetukset

-
#!/bin/sh -e # # rc.local # # This script is executed at the end of each multiuser runlevel. # Make sure that the script will "exit 0" on success or any other # value on error. # # In order to enable or disable this script just change the execution # bits. # # By default this script does nothing. # hdparm -B255 -S60 /dev/sdb # set disk spindown timers to 1,5 hours (-S243) or 1h (-S242) or 30min (-S241) # to check spin status: "hdparm -C /dev/sd?" # hdparm -S242 /dev/sdb & # hdparm -S242 /dev/sdc & # hdparm -S242 /dev/sdd & # hdparm -S242 /dev/sde & # hdparm -S242 /dev/sdf & # hdparm -S242 /dev/sdg & # hdparm -S242 /dev/sdh & # hdparm -S242 /dev/sdi & # hdparm -S242 /dev/sdj & # hdparm -S242 /dev/sdk & # hdparm -S242 /dev/sdl & # hdparm -B255 -S60 /dev/sdb # TOIMII hdparm -B253 -S242 /dev/sdb hdparm -B127 -S241 /dev/sdb hdparm -S241 /dev/sda #toimii WD Whiteillä exit 0
Read more