Nextcloud write permission error while updating

-
Solution:

 sudo chown -R www-data:www-data /var/www/nextcloud

Popular posts from this blog

Tasmota calibration and setup

-
Image
Tasmota default IP: 192.168.0.4 Connect to WLAN Install OTA updates (Firmware Updates from front page) Calibrate Tasmota PowerSet 60.0 (if load is ie. 60w lamp) VoltageSet 231.1 (measured voltage) CurrentSet 259.740 (calculated value) https://tasmota.github.io/docs/Power-Monitoring-Calibration/ Set correct timezone from console (ie. Finland): Backlog0 Timezone 99; TimeStd 0,0,10,1,4,120; TimeDst 0,0,3,1,3,180 Set password and MQTT settings as needed
Read more

/etc/rc.local hdparm disk spindown asetukset

-
#!/bin/sh -e # # rc.local # # This script is executed at the end of each multiuser runlevel. # Make sure that the script will "exit 0" on success or any other # value on error. # # In order to enable or disable this script just change the execution # bits. # # By default this script does nothing. # hdparm -B255 -S60 /dev/sdb # set disk spindown timers to 1,5 hours (-S243) or 1h (-S242) or 30min (-S241) # to check spin status: "hdparm -C /dev/sd?" # hdparm -S242 /dev/sdb & # hdparm -S242 /dev/sdc & # hdparm -S242 /dev/sdd & # hdparm -S242 /dev/sde & # hdparm -S242 /dev/sdf & # hdparm -S242 /dev/sdg & # hdparm -S242 /dev/sdh & # hdparm -S242 /dev/sdi & # hdparm -S242 /dev/sdj & # hdparm -S242 /dev/sdk & # hdparm -S242 /dev/sdl & # hdparm -B255 -S60 /dev/sdb # TOIMII hdparm -B253 -S242 /dev/sdb hdparm -B127 -S241 /dev/sdb hdparm -S241 /dev/sda #toimii WD Whiteillä exit 0
Read more